, it is impossible to say that the organic fertilizers that have just been produced are packaged and transported in the use of organic fertilizers. Generally, some shapes are processed. At this time, organic fertilizers are required. Granulator, so what do you need to prepare before shape processing?
Preparation work of fertilizer granulator machine, for the production of organic fertilizers, the raw materials should reach the required monotonous requirements, and further monotony is required when required. And the raw materials are sieved to remove agglomerates and mechanical impurities.
When the fertilizer granulator machine
is operating, reflect on whether the water, electricity, and gas systems in the equipment are normal, ensure that the water and gas roads are dredged and leak-free, whether the electrical system is normal, and that the heating system, temperature control, and various instruments can be reliable; Test the car at a low speed to observe whether the organic fertilizer production equipment can run normally; start the vacuum pump on the setting table and observe whether the obligation can be normal; lubricate the smooth parts of various equipment. Remove any shortcomings if found. Install the machine head and setting sleeve, choose the specifications of the machine head according to the product type and size, and install the machine head one by one according to the following.
Granulator operation can be started after the thermostat is turned on when the machine is turned on. The machine head and the granulator flange bolts should be tightened again before starting to eliminate the difference in thermal expansion between the bolt and the machine head. The tightening of the machine head bolts is diagonal. Tighten it evenly. When tightening the flange nut of the machine head, the tightness around the four sides is required, otherwise, the material will run away.
When the fertilizer granulator machine is in operation, press the "ready to drive" button, then connect the "drive" button, and then slowly change the screw speed of the healing knob, and the screw speed starts slowly. Then gradually speed up and add a small amount of material. And according to the needs to add enough material, the twin-screw granulator uses a metering feeder to uniformly and uniformly feed, making the organic fertilizer granulator more efficient.